B Terminal Circuit
B TERMINAL CIRCUIT
Description
The terminal "1" (B) circuit supplies power to charge the battery and operate the vehicle's electrical system.
B TERMINAL CIRCUIT
Diagnosis Procedure
Regarding Wiring Diagram information, Electrical Diagrams.
1.CHECK TERMINAL "1" CONNECTION
1. Turn ignition switch OFF.
2. Check if terminal "1" is clean and tight.
Is the inspection result normal?
YES - GO TO 2
NO - Repair terminal "1" connection. Confirm repair by performing complete Starting/Charging system test. Refer to diagnostic station instruction manual.
2.CHECK TERMINAL "1" CIRCUIT
Check voltage between generator connector F6 terminal 1 and ground.
1 - ground : Battery voltage
Is the inspection result normal?
YES - GO TO 3
NO - Check harness for open between generator and fusible link.
3.CHECK TERMINAL "1" CONNECTION (VOLTAGE DROP TEST)
1. Start engine, then engine running at idle and warm.
2. Check voltage between battery positive terminal and generator connector F6 terminal 1.
1 - B+ : Less than 0.2V
Is the inspection result normal?
YES - Terminal "1" circuit is normal. Work Flow.
NO - Check harness between battery and generator for high resistance.