Interior - Seat Back Board Removal Procedure

Classification: BT09-043

Reference: NTB09-077

Date: March 15, 2010

2009 - 2010 MAXIMA
SEAT BACK BOARD REMOVAL PROCEDURE

APPLIED VEHICLES: 2009 - 2010 Maxima (A35)

SERVICE INFORMATION

If the front seat back needs to be removed for any reason, use the Service Procedure in this bulletin.





PARTS INFORMATION

SERVICE PROCEDURE

NOTES:
^ Use this procedure for the front driver or front passenger seat.

^ The photos in this procedure are for the passenger seat. The driver seat is the same.

CAUTION:
Use covers as needed to protect interior surfaces from scratches or damage.

1. Move / adjust the seat bottom and seat back to the full forward position.





2. Remove the seat back finisher as follows:

NOTE:
The seat back finisher is held on with:

^ 2 top hooks

^ 2 side hooks

^ 2 bottom clips

^ 2 elastic straps from toe flap.





a. Reach under the seat and disconnect the 2 elastic straps for the toe flap.





b. Insert your fingers behind the bottom corners of the finisher.

c. Pull the finisher to unsnap the bottom clip.





d. Hold the finisher on the outboard side (side towards the door).

^ For the passenger seat, the outboard side is to the right.

^ For the driver seat, the outboard side is to the left.

e. Pull the finisher to unsnap the outboard side hook.





f. Hold the top of the finisher and push it down about 1 inch.





g. Pull out on the outboard side of the finisher.

h. Reach behind the finisher.





i. Unsnap the inboard side hook.