Service Procedure

SERVICE PROCEDURE





1. Record the radio station presets:

2. Turn the ignition OFF.





3. Disconnect the negative battery cable.





4. Remove the cable nut shown in Figure 2.

NOTE:
This nut fastens the battery cable and fusible link assembly to the positive battery terminal/clamp.

5. Loosen the positive battery terminal/clamp nut.





6. Remove the positive battery terminal/clamp from the battery post.





7. Use a medium size flat blade screwdriver to snap the terminal/clamp clamp loose from the plastic cover.





8. Remove the positive battery terminal/clamp from the cable and plastic cover.

^ Discard the old positive battery terminal/clamp.





9. Remove the plastic cover from the positive cable/fusible link assembly (slide it off).

^ Discard the old plastic cover.





10. Install the new positive battery terminal/clamp.

Tighten clamp nut to:
5.4 Nm (0.55 kg-m, 48 in-lb)

11. Install the positive battery cable/fusible link assembly onto the stud of the terminal/clamp.





12. Install the nut shown in Figure 8.

Tighten nut to:
13.5 Nm (1.4 kg-m, 10 ft-lb)





13. Snap the new plastic cover onto the positive battery terminal/clamp.

14. Reconnect the negative battery cable.
Tighten clamp nut to:
5.4 Nm (0.55 kg-m, 48 in-lb)

15. Reset the clock and the radio station presets.

16. Reinitialize the power windows.

Perform the following initialization procedure for both front windows:

a. Close the door.

b. Turn the ignition switch ON.

c. Open the window-all the way DOWN.

d. Pull all the way UP on the switch and hold (close the window); continue holding the switch all the way UP for 4 seconds after the window is closed.

e. Confirm the window is now operating correctly.

17. If equipped, reinitialize the power sunroof.

a. Turn the ignition ON.

b. Hold the sunroof switch in the tilt up position. Release the switch when the sunroof has reached the full tilt up position.

c. Within 5 seconds of releasing the switch in step b, hold the sunroof switch in the tilt up position again. The sunroof will move from the open position and back to the close position. Release the switch only when the sunroof has reached the full closed position.

^ If the sunroof switch is released at any time during step c, the procedure must be started over again.

^ Leave the ignition ON for at least 2 seconds after the procedure is complete.