Final Drive

FINAL DRIVE


Disassembly and Assembly


DISASSEMBLY





1. Remove differential side bearing inner race (clutch housing side)
(1) according to the following procedures.
a. Set a suitable tool to differential side bearing inner race (clutch housing side).
b. Remove differential side bearing inner race (clutch housing side), using Tool (A).

Tool number : ST33061000 (J-8107-2)

2. Remove speedometer drive gear.





3. Remove final gear bolts, and then remove final gear (1).





4. Remove differential side bearing inner race (transaxle case side) (1) according to the following procedures.
a. Set a suitable tool to differential side bearing inner race (transaxle case side).
b. Remove differential side bearing inner race (transaxle case side), using a suitable tool (A).

INSPECTION AFTER DISASSEMBLY

Gear and Case
Check final gear and differential case. Replace if necessary.

Bearing





Check bearing for damage and unsmooth rotation. Replace if necessary.

CAUTION:
- Replace differential side bearing outer race (clutch housing side) and differential side bearing inner race (clutch housing side) as a set.
- Replace differential side bearing inner race (transaxle case side) and differential side bearing outer race (transaxle case side) as a set.

ASSEMBLY
1. Install final gear, and then tighten final gear bolts to the specified torque. Final Drive.

CAUTION:
Replace final gear and differential case as a set.
2. Install speedometer drive gear.





3. Install differential side bearing inner race (clutch housing side), using a suitable tool (A).

CAUTION:
Replace differential side bearing inner race (clutch housing side) and differential side bearing outer race (clutch housing side) as a set.





4. Install differential side bearing inner race (transaxle case side), using a suitable tool (A).

CAUTION:
Replace differential side bearing inner race (transaxle case side) and differential side bearing outer race (transaxle case side) as a set.