Diagnosis Procedure

BATT/FLUID TEMP SEN


Diagnosis Procedure

1.CHECK TCM POWER SOURCE
1. Turn ignition switch ON. (Do not start engine.)





2. Check voltage between TCM connector terminals and ground.





3. Turn ignition switch OFF.





4. Check voltage between TCM connector terminals and ground.





OK or NG
OK - GO TO 3.
NG - GO TO 2.
2.DETECT MALFUNCTIONING ITEM
Check the following items:
- Harness for short or open between ignition switch and TCM terminals 10, 19
- Harness for short or open between battery and TCM terminal 28
- 10A fuse (No.13, located in the fuse block) and 10A fuse (No.49, located in the IPDM E/R)
- Ignition switch. Description and Operation .
OK or NG
OK - GO TO 9.
NG - Repair or replace damaged parts.
3.CHECK INPUT SIGNAL OF A/T FLUID TEMPERATURE SENSOR
With CONSULT-III
1. Start engine.
2. Select "TCM INPUT SIGNALS" in "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Read out the value of "FLUID TEMP SE".





Without CONSULT-III
1. Start engine.





2. Check voltage TCM connector terminals while warming up A/T.





OK or NG
OK - GO TO 9.
NG - GO TO 4.
4.DETECT MALFUNCTIONING ITEM
Check the following items:
- Harness for short or open between TCM, ECM and terminal cord assembly
- Ground circuit for ECM
Power Supply And Ground Circuit (HR16DE), Power Supply And Ground Circuit (MR18DE).
OK or NG
OK - GO TO 5.
NG - Repair or replace damaged parts.
5. CHECK FLUID TEMPERATURE SENSOR CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect the TCM connector.
3. Check resistance between terminals.










OK or NG
OK - GO TO 9.
NG - GO TO 6.
6. CHECK HARNESS BETWEEN TCM AND TERMINAL CORD ASSEMBLY HARNESS CONNECTOR
1. Turn ignition switch OFF.
2. Disconnect terminal cord assembly harness connector and TCM connector.





3. Check continuity between terminal cord assembly harness connector terminal and TCM connector terminal.





4. If OK, check harness for short to ground and short to power.
5. If OK, check continuity between ground and transaxle assembly.
6. Reinstall any part removed.
OK or NG
OK - GO TO 7.
NG - Repair open circuit or short to ground or short to power in harness or connectors.
7.CHECK A/T FLUID TEMPERATURE SENSOR WITH TERMINAL CORD ASSEMBLY
1. Turn ignition switch OFF.
2. Disconnect terminal cord assembly connector in engine room.





3. Check resistance between terminal cord assembly terminals.





4. Reinstall any part removed.
OK or NG
OK - GO TO 8.
NG - Repair or replace damaged parts.
8.DETECT MALFUNCTIONING ITEM
1. Remove oil pan. Service and Repair .
2. Check the following items:
- A/T fluid temperature sensor





- Check resistance between terminal cord assembly harness connector terminals while changing temperature as shown.





- Harness of terminal cord assembly for short or open
OK or NG
OK - GO TO 9.
NG - Repair or replace damaged parts.
9.CHECK DTC
Perform DTC Confirmation Procedure .
OK or NG
OK - INSPECTION END
NG - GO TO 10.
10.CHECK TCM
1. Check TCM input/output signal. TCM Terminal And Reference Value .
2. If NG, recheck TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK - INSPECTION END
NG - Repair or replace damaged parts.