Removal And Installation

CONTROL LINKAGE


Removal and Installation


REMOVAL
1. Remove the battery. Removal and Replacement.
2. Remove the air duct and air cleaner case. Removal And Installation .





3. Press the release button (1) of select cable and shift cable, and then remove select cable and shift cable from lever of control shaft (2).
4. Shift control lever to neutral position.
5. Remove control lever handle.
6. Remove center console assembly. Removal And Installation.
7. Remove control device assembly bolts.
8. Remove exhaust front tube, center muffler and heat plate. Removal And Installation.
9. Remove bracket.
10. Remove select cable and shift cable from cable mounting bracket.
11. Remove control device assembly from the vehicle.

INSTALLATION
Installation is in the reverse order of removal.
- Shift the control lever to the neutral position.
- Securely assemble each the cables to each lever, mounting bracket, and the control device assembly.





- Be careful about the installation direction, and push control lever handle into control lever.

Arrow Indicates Front





- Make sure that the front/rear claws (1) of control device assembly are in contact with flange of the floor (2).