Cruise Test - Part 2

TROUBLE DIAGNOSIS


Cruise Test - Part 2

1.CHECK STARTING GEAR (D1 ) POSITION
1. Push overdrive control switch. (OD OFF indicator lamp is off.)
2. Move selector lever to "D" position.





3. Accelerate vehicle by half throttle again.
Read gear position. CONSULT-III Function (A/T) .
Does vehicle start from D1 ?
YES - GO TO 2.
NO - . Mark the box on the "Diagnostic Worksheet Chart".
- Vehicle Cannot Be Started From D1 .
- Continue "Road Test".
2.CHECK SHIFT-UP AND SHIFT-DOWN (D
TO D4 TO D2 )
1. Accelerate vehicle to 80 km/h (50 MPH) as shown in the figure.





2. Release accelerator pedal and then quickly depress it fully.
Read gear position and throttle opening. CONSULT-III Function (A/T) .
Does A/T shift from D4 to D2 as soon as accelerator pedal is depressed fully?
YES - GO TO 3.
NO - . Mark the box on the "Diagnostic Worksheet Chart".
- A/T Does Not Shift D1 To D2 Or Does Not Kickdown D4 To D2 .
- Continue "Road Test".
3.CHECK SHIFT-UP (D
TO D3 )
Check shift-up (D2 to D3 )
Specified speed when shifting from D2 to D3 . Vehicle Speed At Which Gear Shifting Occurs .





Read gear position, throttle opening and vehicle speed. CONSULT-III Function (A/T) .
Does A/T shift from D2 to D3 at the specified speed?
YES - GO TO 4.
NO - . Mark the box on the "Diagnostic Worksheet Chart".
- A/T Does Not Shift D3 To D4 .
- Continue "Road Test".
4.CHECK SHIFT-UP (D
TO D4 ) AND ENGINE BRAKE
Release accelerator pedal after shifting from D2 to D3 .





Read gear position, throttle opening and vehicle speed. CONSULT-III Function (A/T) .
Does A/T shift from D3 to D4 and does vehicle decelerate by engine brake?
YES - 1. Stop vehicle.
2. Go to Cruise Test - Part 3 .
NO - . Mark the box on the "Diagnostic Worksheet Chart".
- A/T Does Not Shift D3 To D4 .
- Continue "Road Test".