Removal and Installation

PARKING BRAKE CONTROL


Removal and Installation


REMOVAL
1. Remove center console assembly. Removal And Installation.
2. Disconnect parking brake switch connector.
3. Loosen adjusting nut.
4. Remove equalizer from rear cable terminal ends.





5. Take off rear cable clip, and unplug rear cable outward.

NOTE:
Close opening to take off clip.
6. Remove device assembly nuts, and remove device assembly.
7. Remove rear brake shoe and remove rear cable from the operating lever. Removal and Installation.
8. Remove the exhaust center tube and heat plate. Removal And Installation.
9. Remove rear cable bolt and nut, and then remove rear cable.
10. Remove adjusting nut and discard. Remove the front cable from the device assembly.

CAUTION:
Discard the adjusting nut, do not reuse.

INSTALLATION
Installation is in the reverse order of removal.
- Adjust clearance of rear brake shoes. Adjustments.