DTC Confirmation Procedure

CONTROL UNIT (RAM), CONTROL UNIT (ROM)


DTC Confirmation Procedure


CAUTION:
If performing this "DTC Confirmation Procedure" again, always turn ignition switch OFF and wait at least 10 seconds before continuing.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
2. Touch "START".
3. Start engine.
4. Run engine for at least 2 seconds at idle speed.
5. If the check result is NG, go to Diagnosis Procedure.