DTC Confirmation Procedure

BATT/FLUID TEMP SEN


DTC Confirmation Procedure


CAUTION:
- Always drive vehicle at a safe speed.
- If performing this "DTC Confirmation Procedure" again, always turn ignition switch OFF and wait at least 10 seconds before continuing.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Start engine.
2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
3. Touch "START".
4. Drive vehicle under the following conditions.
SLCT LVR POSI: "D" position
VEHICLE SPEED: Higher than 20 km/h (12 MPH)
5. If the check result is NG, go to Diagnosis Procedure .

WITHOUT CONSULT-III
1. Start engine.
2. Drive vehicle under the following conditions.
Selector lever position: D position
Vehicle speed: higher than 20 km/h (12 MPH)
3. Perform self-diagnosis. Diagnosis Procedure Without CONSULT-III .
4. If the check result is NG, go to Diagnosis Procedure .