DTC Confirmation Procedure

VEHICLE SPEED SIGNAL


DTC Confirmation Procedure


CAUTION:
- Always drive vehicle at a safe speed.
- If performing this "DTC Confirmation Procedure" again, always turn ignition switch OFF and wait at least 10 seconds before continuing.
After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
2. Touch "START".
3. Start engine and accelerate vehicle from 0 to 25 km/h (0 to 16 MPH).
4. If the check result is NG, go to Diagnosis Procedure .

WITHOUT CONSULT-III
1. Start engine.
2. Drive vehicle under the following conditions:
Selector lever position: "D" position
Vehicle speed: Higher than 25 km/h (16 MPH)
3. Perform self-diagnosis. Diagnosis Procedure Without CONSULT-III .
4. If the check result is NG, go to Diagnosis Procedure .