Rear LH

DOOR LOCK ACTUATOR:_:REAR LH





Description
Locks/unlocks the door with the signal from BCM.




Component Function Check
1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test ("DOOR LOCK").
2. Touch "ALL LOCK" or "ALL UNLOCK" to check that it works normally.
Is the inspection result normal?
YES - Door lock actuator is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1.CHECK DOOR LOCK ACTUATOR SIGNAL
Check voltage between BCM connector M17 terminals 8, 10 and ground.





Check trunk lamp switch.





Is the inspection result normal?
YES - GO TO 3
NO - GO TO 2
2.CHECK DOOR LOCK ACTUATOR CIRCUIT
1. Disconnect BCM and rear door lock actuator LH connectors.





2. Check continuity between BCM connector M17 (A) terminals 8, 10 and rear door lock actuator LH connectors D205 (B) terminals 1, 2.





3. Check continuity between BCM connector and ground.





Is the inspection result normal?
YES - Replace rear door lock actuator LH.
NO - Repair or replace harness.
3.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- Inspection End.