Rear RH

DOOR LOCK ACTUATOR:_:REAR RH





Description
Locks/unlocks the door with the signal from BCM.




Component Function Check
1.CHECK FUNCTION
1. Use CONSULT-III to perform Active Test ("DOOR LOCK").
2. Touch "ALL LOCK" or "ALL UNLOCK" to check that it works normally.
Is the inspection result normal?
YES - Door lock actuator is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, [1][2]Electrical Diagrams.
1.CHECK DOOR LOCK ACTUATOR SIGNAL





Check voltage between BCM connector M17 terminals 8, 10 and ground.





Is the inspection result normal?
YES - GO TO 3
NO - GO TO 2
2.CHECK DOOR LOCK ACTUATOR CIRCUIT
1. Disconnect BCM and rear door lock actuator RH connectors.





2. Check continuity between BCM connector M17 (A) terminals 8, 10 and rear door lock actuator RH connector D305 (B) terminals
5, 6.





3. Check continuity between BCM connector and ground.





Is the inspection result normal?
YES - Replace rear door lock actuator RH.
NO - Repair or replace harness.
3.CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- Inspection End.