Work Flow

DIAGNOSIS AND REPAIR WORK FLOW


Work Flow


NOTE:
*: Use the CONSULT-III.
1.VEHICLE BROUGHT TO WORKSHOP
Vehicle brought to workshop.
- GO TO 2.
2.CUSTOMER PROBLEM ANALYSIS
Interview the customer and confirm the trouble.
- GO TO 3.
3.CHECK DTC AND FREEZE FRAME DATA*
1. Check and record a DTC and Freeze Frame Data.
2. Clear the DTC and Freeze Frame Data.
3. Reconfirm the DTC.
- Reconfirm the DTC based on the recorded DTC and Freeze Frame Data.

NOTE:
If any of the DTCs U0123, U0124, U0126, and U0293 is output together with a CAN communication DTC, first check the appropriate sensor for a momentary open circuit.





A - GO TO 4.
B - GO TO 5.
C - GO TO 6.
4.DIAGNOSTIC TROUBLE CODE CHART
Proceed to Diagnostic Trouble Code Chart.
- GO TO 7.
5.SYMPTOM SIMULATION
Proceed to Diagnostic System.
- GO TO 6.
6.PROBLEM SYMPTOM TABLE
Proceed to Problem Symptom Table.
- GO TO 7.
7.CIRCUIT INSPECTION*
Circuit inspection.
- GO TO 8.
8.IDENTIFICATION OF PROBLEM
Identification of problem.
- GO TO 9.
9.REPAIR OR REPALCEMENT
Repair or replacement.
- GO TO 10.
10.CONFIRMATION TEST*
Confirmation test.
- END