Push-Button Ignition Switch Position Indicator

PUSH-BUTTON IGNITION SWITCH POSITION INDICATOR





Description
The switch that changes the power supply position.
BCM maintains the power supply position status.
BCM changes the power supply position with the operation of the push-button ignition switch.




Component Function Check
1. CHECK FUNCTION
With CONSULT-III
1. Check push-button ignition switch ("LOCK INDICATOR","ACC INDICATOR" and "IGNITION ON IND") in Active Test Mode with CONSULT-III.





Is the inspection result normal?
YES - Inspection End.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, Power Distribution System.
1. CHECK PUSH-BUTTON IGNITION SWITCH INPUT SIGNAL





1. Turn ignition switch OFF.
2. Disconnect push-button ignition switch.
3. Check voltage between push-button ignition switch harness connector and ground.





Is the inspection normal?
YES - GO TO 2
NO - Check the following.
- 10A fuse [No. 9, located in fuse block (J/B)]
- Harness for open or short between push-button ignition switch and fuse.
2. CHECK PUSH-BUTTON IGNITION SWITCH CIRCUIT





1. Disconnect BCM and push-button ignition switch.
2. Check continuity between BCM harness connector and push-button ignition switch harness connector.










3. Check continuity between BCM harness connector and ground.





Is the inspection normal?
YES - GO TO 3
NO - Repair or replace harness.
3. CHECK PUSH-BUTTON IGNITION SWITCH
SEE Component Inspection.
Is the inspection normal?
YES - GO TO 4
NO - Replace push-button ignition switch. Removal And Installation Intelligent Key System.
4. CHECK INTERMITTENT INCIDENT
Intermittent Incident.
- Inspection End.




Component Inspection
1. CHECK PUSH-BUTTON IGNITION SWITCH





Check push-button ignition switch.





Is the inspection result normal?
YES - Inspection End.
NO - Replace push-button ignition switch. Removal And Installation Intelligent Key System.