Evaporative Vapor Pressure Sensor: Service and Repair

EVAP CONTROL SYSTEM PRESSURE SENSOR


Removal and Installation


REMOVAL
1. Remove rear stabilizer bar clamps and position rear stabilizer bar aside. Rear Stabilizer.
2. Disconnect EVAP hose from EVAP canister.
3. Disconnect EVAP control system pressure sensor.
4. Remove EVAP control system pressure sensor and O-ring.

CAUTION:
Discard the O-ring, do not reuse.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
Always replace O-ring with a new one.