Removal And Installation

EPS CONTROL UNIT


Removal and Installation


Removal
1. Remove the engine cover.
2. Remove the front wiper arm cover and wiper arm and blade assembly. Removal and Installation Service and Repair, "FRONT WIPER
DRIVE ASSEMBLY : Removal and Installation"
3. Remove the cowl top weatherstrip.
4. Remove the cowl top end caps. Service and Repair
5. Remove the cowl top finisher assembly. Service and Repair
6. Disconnect the washer hose.
7. Remove the strut brace.
8. Remove the wiper motor and connecting rod assembly. Removal and Installation Service and Repair, "FRONT WIPER DRIVE
ASSEMBLY : Removal and Installation".
9. Disconnect the 12-volt battery negative terminal.
10. Remove the left cowl extension.
11. Disconnect the MAF sensor connector.
12. Remove the air cleaner duct, blow-by hose and air cleaner duct hose. Service and Repair.
13. Remove the fuse and fusible link box.
14. Disconnect the harness clips.





15. Disconnect the EPS DC/DC converter connector (2), EPS sensor connector (3), and EPS motor connector (4) from the EPS
ECU (1).

NOTE:
For EPS DC/DC converter connector (2) and EPS motor connector (4), perform the following:
- Pull lock plate (5) up until it stops.
- Turn the lock lever (6) until it stops.
- Pull the connector to disconnect it.
16. Remove the EPS control unit nut and bolts and EPS control unit.

Installation
Installation is in the reverse order of removal.