Child Restraint: Service and Repair

REAR PARCEL SHELF FINISHER


Removal and Installation - Child Anchor and Key Cylinder Covers


REMOVAL





1. Lift the child anchor cover or key cylinder cover to a full open position.





2. Rotate the child anchor cover or key cylinder cover as shown to disengage the left hinge (A) of the cover from the left retaining pin, then slide cover slightly back to the left to remove the right hinge (B) from the right retaining pin.

INSTALLATION





1. Install the child anchor cover or key cylinder cover by gently sliding the right hinge (A) of the child anchor cover or key cylindercover onto the right retaining pin (B).





2. Gently push down on the child anchor cover or key cylinder cover left hinge (A) to engage it to the left retaining pin (B). A snapping sound will be heard once the hinge and the retaining pin are locked together.

CAUTION:
Make sure the left hinge is completely aligned with the left retaining pin. If the two items are not aligned, and the cover is forced it may result in the breaking of the retaining pin and the rear parcel shelf finisher needing to be replaced.





3. Lower the child anchor cover or key cylinder cover to the fully closed position.