Yaw Rate Sensor: Service and Repair

YAW RATE/SIDE/DECEL G SENSOR


Removal and Installation


REMOVAL

CAUTION:
Do not use power tool, drop, or strike yaw rate/side/decel G sensor, because it is sensitive to impact.
1. Remove center console. Disassembly And Assembly.
2. Disconnect yaw rate/side/decel G sensor harness connector.
3. Remove yaw rate/side/decel G sensor nuts and remove yaw rate/side/decel G sensor.

INSTALLATION





Installation is the reverse order of removal.
- Arrow Indicates Front

CAUTION:
- Do not use power tool, drop, or strike the yaw rate/side/decel
G sensor, because it is sensitive to impact.
- After erasing Brake ECU memories, perform zero adjustment of following sensors and initialization of linear solenoid valve.
These procedures should be performed on a flat place:
- Steering angle sensor. Description Special Repair Requirement Description Special Repair Requirement, "PERFORM ZERO
POINT OF STEERING ANGLE SENSOR : Description".
- Yaw rate/side/decel G sensor. Description Special Repair Requirement, "PERFORM
ZERO POINT OF YAW RATE/SIDE/DECEL G SENSOR : Description".
- Brake stroke sensor. Description.
- Linear solenoid valve. Description Special Repair Requirement, "PERFORM INITIALIZATION OF LINEAR SOLENOID VALVE
AND CALIBRATION : Description".