Power Window Main Switch

POWER WINDOW SERIAL LINK:_:POWER WINDOW MAIN SWITCH





Description
Main power window and door lock/unlock switch, power window and door lock/unlock switch RH and BCM transmit and receive the signal by power window serial link.
The signal mentioned below is transmitted from BCM to main power window and door lock/unlock switch and power window and door lock/unlock switch RH
- Keyless power window down signal
The signal mentioned below is transmitted from main power window and door lock/unlock switch to power window and door lock/unlock switch RH
- Front door window RH operation signal
- Power window control by key cylinder switch signal
- Power window lock switch signal
- Retained power operation signal




Component Function Check
1. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL
Check ("CDL LOCK SW ", "CDL UNLOCK SW") in "DATA MONITOR" mode for "POWER DOOR LOCK SYSTEM" with CONSULT-III. Door Lock.





Is the inspection result normal?
YES - Power window serial link is OK.
NO - SEE Diagnosis Procedure.




Diagnosis Procedure
Regarding Wiring Diagram information, With Left And Right Power Window Anti-Pinch System.

Power Window Serial Link Check
1. CHECK MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH OUTPUT SIGNAL





1. Remove Intelligent Key, and close front door LH and RH.
2. Check signal between BCM connector and ground with oscilloscope when door lock and unlock switch (LH and RH) is turned to "LOCK" or "UNLOCK".
3. Check that signals which are shown in the figure below can be detected during 10 second just after door lock and unlock switch
(LH and RH) is turned to "LOCK" or "UNLOCK".





Is the inspection result normal?
YES - Power window serial link is OK.
NO - GO TO 2
2. CHECK POWER WINDOW SERIAL LINK CIRCUIT





1. Turn ignition switch OFF.
2. Disconnect BCM and main power window and door lock/unlock switch.
3. Check continuity between BCM connector (A) and main power window and door lock/unlock switch connector (B).





4. Check continuity between BCM connector (A) and ground.





Is the inspection result normal?
YES - Replace main power window and door lock/unlock switch. LH&RH Front Window Anti-Pinch. After that, LH&RH Front Window Anti-Pinch.
NO - Repair or replace harness.