B2608
B2608 STARTER RELAY
DTC Logic
DTC DETECTION LOGIC
NOTE:
- If DTC B2608 is displayed with DTC U1000, first perform the trouble diagnosis for DTC U1000. Body Control System With Intelligent Key System.
- If DTC B2608 is displayed with DTC U1010, first perform the trouble diagnosis for DTC U1010. Body Control System With Intelligent Key System.
- If DTC B2608 is displayed with DTC B210D (IPDM E/R), first perform the trouble diagnosis for DTC B210D. Security System With Intelligent Key System.
DTC CONFIRMATION PROCEDURE
1.PERFORM DTC CONFIRMATION PROCEDURE
1. Press push-button ignition switch under the following conditions to start engine.
CVT models
- Selector lever: In the P position
- Brake pedal: Depressed
M/T models
- Shift lever: In the Neutral position
- Clutch pedal: Depressed
2. Wait 1 second after engine started.
3. Check DTC in "Self Diagnostic Result" mode of "BCM" using CONSULT-III.
Is DTC detected?
YES - Go to SEE Diagnosis Procedure.
NO - INSPECTION END
Diagnosis Procedure
1.CHECK DTC OF IPDM E/R
Check DTC in "Self Diagnostic Result" mode of "IPDM E/R" using CONSULT-III.
Is DTC detected?
YES - Perform the trouble diagnosis related to the detected DTC. Testing and Inspection.
NO - GO TO 2.
2.CHECK STARTER RELAY CIRCUIT
1. Turn ignition switch OFF.
2. Disconnect IPDM E/R connector.
3. Disconnect BCM connector.
4. Check continuity between IPDM E/R harness connector and BCM harness connector.
5. Check continuity between IPDM E/R harness connector and ground.
Is the inspection result normal?
YES - GO TO 3.
NO - Repair or replace harness.
3.REPLACE IPDM E/R
1. Replace IPDM E/R. IPDM E/R (With I-Key).
2. Perform DTC CONFIRMATION PROCEDURE for DTC B2608. SEE DTC Logic.
Is DTC B2608 detected again?
YES - INSPECTION END
NO - GO TO 4.
4.REPLACE BCM
1. Replace BCM. Removal And Installation With Intelligent Key System.
2. Perform initialization of BCM and registration of all Intelligent Keys using CONSULT-III.
For initialization and registration procedures, refer to CONSULT-III Operation Manual NATS-IVIS/NVIS.
- INSPECTION END