Rear Fillet Molding

FILLET MOLDING


REAR FILLET MOLDING : Removal and Installation


REMOVAL
1. Remove filet molding fixing clip from end of sill cover.




Broken Triangle : Pawl

2. Remove rear fillet molding rear side fixing pawls.

CAUTION:
Never pull the rear fillet molding strongly.




Broken Circle : Clip

3. Using remover tool (A), disengage the clips from rear fillet molding by starting from rear side.

CAUTION:
- Apply a protective tape (B) on the body to protect the painted surface from damage.
- Never pull the rear fillet molding strongly.

INSTALLATION
Note the following items, and then install in the reverse order of removal.

CAUTION:
- Always replace fillet molding fixing clips.
- When installing rear fillet molding, check that blind clips and pawls are securely fitted in panel holes on body, and then press them in.