Removal And Installation

MAP LAMP


Removal and Installation


CAUTION:
Disconnect the battery negative terminal or the fuse.

REMOVAL
1. Remove the lens (1).





- Insert a remover tool (A) into the gap between the lens.
- Disengage the lens fixing pawls, and then remove the lens.

CAUTION:
Use a remover tool wrapped in tape.





2. Press pawl in the direction shown by the arrow in the figure using a remover tool (A), and then pull the map lamp housing (1) in the direction shown by the arrow in the figure.

CAUTION:
Use a remover tool wrapped in tape.
3. Disconnect map lamp harness connector, and then remove map lamp housing.

INSTALLATION
Install in the reverse order of removal.