Passenger Select Unlock Relay Circuit Inspection (With Intelligent Key)

POWER DOOR LOCK SYSTEM


Passenger Select Unlock Relay Circuit Inspection (With Intelligent Key)

1.CHECK PASSENGER SELECT UNLOCK RELAY CIRCUIT

NOTE:
Passenger select unlock relay must remain connected during this step.
1. Turn ignition switch OFF.
2. Disconnect BCM and inoperative rear door lock actuator.





3. Check continuity between BCM connector (A) M20 terminal 65 and rear door lock actuator LH connector (B) D205 terminal 3 or rear door lock actuator RH connector (C) D305 Terminal 3.





4. Check continuity between BCM connector (A) M20 terminal 65 and body ground.





OK or NG
OK - GO TO 4
NG - GO TO 2
2.CHECK PASSENGER SELECT UNLOCK RELAY INPUT
1. Disconnect passenger select unlock relay.





2. Check continuity between BCM connector (A) M20 terminal 65 and passenger select unlock relay connector (B) M2 terminal 3.





3. Check continuity between BCM connector (A) M20 terminal 65 and body ground.





OK or NG
OK - GO TO 3
NG - Repair or replace harness between BCM and relay.
3.CHECK PASSENGER SELECT UNLOCK RELAY OUTPUT





1. Check continuity between passenger select unlock relay connector (A) M2 terminal 4 and rear door lock actuator LH connector (B) D205 or rear door lock actuator RH connector (C) D305 terminal 3.





2. Check continuity between passenger select unlock relay connector (A) M2 terminal 4 and ground.





OK or NG
OK - Replace passenger select unlock relay.
NG - Repair or replace harness between relay and actuator.
4.CHECK REAR DOOR LOCK ACTUATOR ASSEMBLY
1. Reconnect BCM.





2. Check voltage between rear door lock actuator connector LH (A)
D205 or rear door lock actuator connector RH (B) D305 terminals 2 and 3.










3. Check voltage between rear door lock actuator connector LH (A)
D205 or rear door lock actuator connector RH (B) D305 terminals 2 and 3.





OK or NG
OK - Replace rear door lock actuator. Rear Door Lock .
NG - Repair or replace harness between actuator and splice.