Removal and Installation

FRONT SEAT


Removal and Installation


CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- Before removal, be sure to turn ignition switch OFF, disconnect both battery terminals, and then wait for at least three minutes.

MANUAL SEAT

Removal
1. Disconnect the negative and positive battery terminals, then wait at least three minutes.





2. Remove the rear leg covers.





3. Remove the front leg covers.
4. Remove the mounting bolts on the back side of the front seat. (TORX bolt: T50)
5. Remove the mounting bolts on the front side of the front seat. (TORX bolt: T50)
6. Disconnect the harness connector under the seat and remove harness securing clips.
7. Set seatback in a neutral position, and then remove front seat from the vehicle.

Installation
Installation is in the reverse order of removal. Be careful of the following three points.
- Before the installation, confirm that the inside and outside slide rails are locked at the same positions.
- Confirm that the slide rail location pin is set to the hole on the floor.
- Clamp the harness in position.