Removal And Installation

REFRIGERANT LINES


Removal and Installation of Compressor - HR16DE

HR16DE






REMOVAL
1. Use the recovery/recycling equipment to evacuate the refrigerant. Manual Air Conditioner.





2. Disconnect the low-pressure flexible hose nut (A) and high-pressure flexible hose bolt (B) and remove the hoses from compressor.

CAUTION:
Cap or wrap the joint of compressor, low-pressure flexible hose and high-pressure flexible hose with suitable material such as vinyl tape to avoid the entry of air.
3. Disconnect the compressor harness connector (C)
4. Remove the engine undercover, using power tools.
5. Remove the A/C drive belt. Removal and Replacement.





6. Remove the bolts (A) from the compressor (1), using power tools.
7. Remove the compressor (1) downward from the engine compartment.

INSPECTION FOR CLUTCH DISC TO PULLEY CLEARANCE





1. Check the clearance around the entire periphery of the clutch disc and pulley using a suitable tool as shown.






2. If specified clearance is not obtained, replace compressor.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- Replace O-rings of low-pressure flexible hose and high-pressure flexible hose with new ones, and apply compressor oil when installing.
- When recharging refrigerant, check for leaks. Checking Of Refrigerant Leaks.