Removal and Installation

REAR COMBINATION LAMP


Removal and Installation


HATCHBACK

CAUTION:
It is not necessary to remove the luggage side finisher. Doing so may render the part damaged or unusable.

Removal





1. Remove the access panels using suitable tool.
2. Remove rear combination lamp assembly nuts.
3. Pull the rear combination lamp assembly toward rear of the vehicle.
4. Disconnect rear combination lamp connector, and remove rear combination lamp assembly.

Installation
Installation is in the reverse order of removal.

SEDAN

Removal
1. Remove trunk side finisher. Service and Repair.





2. Remove the rear combination lamp assembly nuts (1).
3. Remove the rear combination lamp assembly (2).
4. Remove the rear combination lamp assembly seal (3).

Installation
Installation is in the reverse order of removal.