Shift Indicator - CVT: Testing and Inspection

CVT INDICATOR


CVT Indicator Does Not Illuminate

1.CHECK SEGMENT OF CVT INDICATOR





Perform self-diagnosis of combination meter. Reading and Clearing Diagnostic Trouble Codes, "Self-
Diagnosis Mode of Combination Meter".
Are all segments displayed?
YES - GO TO 2.
NO - Replace combination meter. Removal And Installation, "Removal
and Installation".
2.CHECK COMBINATION METER (CONSULT-III)
1. Connect CONSULT-III.
2. Select "METER/M&A" on CONSULT-III, and perform self-diagnosis of combination meter. CONSULT-III Function (Meter/M&A), "CONSULT-III Function (METER/M&A)".
Self-diagnostic results content
No malfunction detected- GO TO 3.
Malfunction detected- Check applicable parts, and repair or replace as necessary.
3.CHECK COMBINATION METER INPUT SIGNAL
Use "DATA MONITOR" of "METER/M&A" on CONSULT-III. Confirm each indication on the monitor when operating the CVT selector lever.





OK or NG
OK - Replace combination meter. Removal And Installation.
NG - GO TO 4.
4.CHECK SELF-DIAGNOSIS RESULTS OF TCM
Perform self-diagnosis of TCM. CVT RE0F08B.
OK or NG
OK - Check TCM input/output signal. Repair or replace malfunctioning part, if necessary. Testing and Inspection.
NG - Check applicable part, and repair or replace as necessary.