Removal And Installation

CONTROL LINKAGE


Removal and Installation


REMOVAL
1. Remove the battery. Removal and Replacement.
2. Remove the air duct and air cleaner case. Removal And Installation .





3. Press the release button (1) of select cable and shift selector cable, and then remove select cable and shift selector cable from select lever of control shaft (2).
4. Move shift selector to neutral position.
5. Remove shift selector handle.
6. Remove center console assembly. Removal And Installation.
7. Remove M/T shift selector assembly bolts.
8. Remove exhaust front tube, center muffler and heat plate. Removal And Installation.
9. Remove cable support bracket.
10. Remove select cable and shift selector cable from cable mounting bracket.
11. Remove M/T shift selector assembly from the vehicle.

INSTALLATION
Installation is in the reverse order of removal.
- Move the shift selector to the neutral position.
- Securely assemble each of the cables to each select lever of control shaft, mounting bracket, and the M/T shift selector assembly.





- Be careful about the installation direction, and push shift selector handle onto shift selector.

CAUTION:
Do not reuse shift selector handle.





- Make sure that the front/rear claws (1) of M/T shift selector assembly are in contact with flange of the floor (2).