Operation CHARM: Car repair manuals for everyone.

P0746


P0746 PRESSURE CONTROL SOLENOID A





Description
- The line pressure solenoid valve is included in the control valve assembly.
- The line pressure solenoid valve regulates the oil pump discharge pressure to suit the driving condition in response to a signal sent from the TCM.




CONSULT-III Reference Value in Data Monitor Mode









On Board Diagnosis Logic
- This is an OBD-II self-diagnostic item.
- Diagnostic trouble code "P0746" with CONSULT-III is detected under the following conditions.
- Unexpected gear ratio was detected in the LOW side due to excessively low line pressure.




Possible Cause
- Line pressure control system
- Secondary speed sensor
- Primary speed sensor




DTC Confirmation Procedure

CAUTION:
Always drive vehicle at a safe speed.

NOTE:
If "DTC Confirmation Procedure" has been previously performed, always turn ignition switch OFF and wait at least 10 seconds before performing the next test.
After the repair, touch "ERASE" on "SELF-DIAG RESULTS" and then perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III
1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
2. Start engine and maintain the following conditions for at least 10 consecutive seconds. Test start from 0 km/h (0 MPH).
ATF TEMP SEN: 1.0 - 2.0 V
ACC PEDAL OPEN: More than 1.0/8
RANGE: "D" position
VEHICLE SPEED: 10 km/h (6 MPH) More than
Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test.
3. If DTC is detected, go to SEE Diagnosis Procedure.

WITH GST
Follow the procedure "WITH CONSULT-III".




Diagnosis Procedure
1.CHECK LINE PRESSURE
Perform line pressure test. CVT RE0F08B.
OK or NG
OK - GO TO 2.
NG - Repair or replace damaged parts. CVT RE0F08B.
2.DETECT MALFUNCTIONING ITEM
Check line pressure solenoid valve. CVT.
OK or NG
OK - GO TO 3.
NG - Repair or replace damaged parts.
3.CHECK SECONDARY SPEED SENSOR SYSTEM AND PRIMARY SPEED SENSOR SYSTEM
Check secondary speed sensor system and primary speed sensor system. CVT CVT CVT CVT CVT, P0715 P0715 P0715 P0715 P0715.
OK or NG
OK - GO TO 4.
NG - Repair or replace damaged parts.
4.DETECT MALFUNCTIONING ITEM
Check the following:
- Power supply and ground circuit for TCM. P1701.
- The TCM pin terminals for damage or loose connection with harness connector.
OK or NG
OK - GO TO 5.
NG - Repair or replace damaged parts.
5.CHECK DTC
Perform SEE DTC Confirmation Procedure.
OK or NG
OK - INSPECTION END
NG - Replace the transaxle assembly or TCM. Transaxle Assembly.