Rear Door Lock

REAR DOOR LOCK


Removal and Installation


REMOVAL
1. Remove the partition glass. Removal and Installation .
2. Support door glass while lifting it up to the door window completely closed position.





3. Remove inside handle bolt, slide handle toward rear of vehicle, disconnect it from the door panel, and remove the inside handle.





4. Disconnect the inside handle and lock knob cables from the inside handle.

CAUTION:
During removal and installation, do not to bend the ends of the lock knob cable and inside handle cable.





5. Remove the door side grommet, and the outside handle escutcheon screw.





6. Pull the outside handle forward (1), while removing outside handle escutcheon (2).





7. Pull outside door handle forward (1), and slide it toward the rear of the vehicle to remove (2).





8. Remove the front and rear gaskets.





9. Remove the door lock assembly screws.










10. Slide the outside handle bracket toward the rear of vehicle, remove the outside handle bracket and the door lock assembly.
11. If equipped, disconnect the door lock assembly electrical connector.





12. Disconnect the outside handle cable from the outside handle bracket.

INSTALLATION
Installation is in the reverse order of removal.

CAUTION:
- To install each rod, be sure to rotate the rod holder until a click is felt.
- When installing door lock assembly, be careful when rotating the outside handle cable as shown.





- Place the outside handle bracket cable on the inside of door lock assembly before installing.