Procedures

SUNROOF


Inspection


WIND DEFLECTOR





Check that the wind deflector (1) moves freely within the sunroof unit assembly while manually pressing down and releasing. If a malfunction is detected, remove and visually check the deflector for damage, deteriorated components, or foreign objects within mechanism.
Check to determine if a sufficient amount of grease has been applied to the pivot areas for non-binding operation, if not add grease as required. If it is damaged, replace it with a new one. If no damage is found, reinstall it properly.
Arrow indicates Vehicle front

LINK ASSEMBLY AND WIRE

NOTE:
Before replacing a suspect part, make sure it is the source of noise being experienced.
1. Check link to determine if coated film has peeled off to such an extent that substrate is visible. Check also to determine if link is the source of noise. If it is, replace it.
2. Visually check to determine if a sufficient amount of grease has been applied to wire or rail groove of the sunroof unit assembly. If not, add grease as required.
3. Check wire for any damage or deterioration. If any damage is found, replace sunroof unit assembly.

WEATHERSTRIP
1. Visually check weatherstrip for damage, deterioration, or deformation.
- Open glass lid assembly enough to inspect front edge of weatherstrip.
- Tilt up glass lid assembly fully to inspect sides and rear edge of weatherstrip.
If any area of the weatherstrip is found to be damaged, replace the glass lid assembly. Removal and Replacement .
2. Check for leakage around glass lid.
- Close glass lid fully.
- Pour water around surface to determine area of concern.
- For gaps or misalignment, adjust glass lid to specifications. Adjustments .
- For damaged sealing surfaces, either replace glass lid Removal and Replacement , or repair the panel .

DRAIN HOSES
Hatchback Models










Sedan Models










1. Remove headlining. Component.
2. Visually check drain hoses for:
- Proper connection at sunroof unit assembly.
- Damage, pinch, cracks, deterioration.
- Proper fastening and routing on body panels.
3. Pour water through drain hoses to determine watertight performance.
If a damaged or leaking portion in any drain hose is found, replace entire drain hose as an assembly.