Transmission Adjustment (2)

ASSEMBLY


Adjustment (2)

When any parts listed below are replaced, adjust total end play and reverse clutch end play.






TOTAL END PLAY





- Measure clearance between reverse clutch drum and needle bearing for oil pump cover.
- Select proper thickness of bearing race so that end play is within specifications.





1. Measure dimensions (K) and (L), and then calculate dimension
(J).





a. Measure dimension (K).





b. Measure dimension (L).
c. Calculate dimension (J).










2. Measure dimension (M).
a. Place bearing race and needle bearing on oil pump assembly.





b. Measure dimension (M).










c. Measure thickness of straightedge (t).






3. Adjust total end play (T1).






- Select proper thickness of bearing race so that total end play is within specifications. Refer to "Parts
Information" for bearing race selection.

REVERSE CLUTCH END PLAY





- Measure clearance between oil pump cover and thrust washer for reverse clutch drum.
- Select proper thickness of thrust washer so that end play is within specification.





1. Measure dimensions O and P), and then calculate dimension
N).





a. Place thrust washer on reverse clutch drum.
b. Measure dimension (O).





c. Measure dimension (P).
d. Calculate dimension (N).










2. Measure dimensions (R) and (S), and then calculate dimension
(Q).





a. Measure dimension (R).





b. Measure dimension (S).
c. Calculate dimension (Q).






3. Adjust reverse clutch end play (T2).






- Select proper thickness of thrust washer so that reverse clutch end play is within specifications. Refer to "Parts Information" for thrust washer selection.