Transmission Assembly (1)

ASSEMBLY


Assembly (1)






1. Drive each differential side oil seal evenly using Tools (Transaxle case side) and suitable tool (Convertor housing side) so that differential side oil seal protrudes by the dimension (C) or
(D) respectively.
(1): LH differential side oil seal
(2): RH differential side oil seal
(A): Transaxle case side
(B): Converter housing side











NOTE:
Differential side oil seal pulling direction is used as the reference.
2. Install O-ring on governor cap.

CAUTION:
- Do not reuse O-ring.
- Apply ATF to O-ring.
3. Install governor cap in transaxle case.
4. Install snap ring in transaxle case.





5. Install parking actuator support (1) on transaxle case.
(A): Inside
(B): Outside

CAUTION:
Be careful with the direction of parking actuator support (1).
6. Tighten parking actuator support bolts to the specified torque. Component.





7. Install parking pawl (2) on transaxle case, and fix it with parking shaft (1).





8. Install return spring (2) on parking shaft (3) and parking pawl (1) using a suitable tool.