Cruise Test - Part 2

Cruise Test - Part 2
1.CHECK STARTING GEAR (D1 ) POSITION
1. Push overdrive control switch. (OD OFF indicator lamp is off.)
2. Move selector lever to "D" position.





3. Accelerate vehicle by half throttle again.
Read gear position. SEE CONSULT-III Function (TRANSMISSION) .
Does vehicle start from D1 ?
YES - GO TO 2.
NO - - Mark the box on the "Diagnostic Worksheet Chart".
- Go to .
- Continue "Road Test".
2.CHECK SHIFT-UP AND SHIFT-DOWN (D
TO D4 TO D2 )
1. Accelerate vehicle to 80 km/h (50 MPH) as shown in the figure.





2. Release accelerator pedal and then quickly depress it fully.
Read gear position and throttle opening. SEE CONSULT-III Function (TRANSMISSION), "CONSULT-III Function (TRANSMISSION)" .
Does A/T shift from D4 to D2 as soon as accelerator pedal is depressed fully?
YES - GO TO 3.
NO - - Mark the box on the "Diagnostic Worksheet Chart".
- Go to .
- Continue "Road Test".
3.CHECK SHIFT-UP (D
TO D3 )
Check shift-up (D2 to D3 )
Specified speed when shifting from D2 to D3 . SEE Vehicle Speed at Which Gear Shifting Occurs .





Read gear position, throttle opening and vehicle speed. SEE CONSULT-III Function (TRANSMISSION) .
Does A/T shift from D2 to D3 at the specified speed?
YES - GO TO 4.
NO - - Mark the box on the "Diagnostic Worksheet Chart".
- Go to .
- Continue "Road Test".
4.CHECK SHIFT-UP (D
TO D4 ) AND ENGINE BRAKE
Release accelerator pedal after shifting from D2 to D3 .





Read gear position, throttle opening and vehicle speed. SEE CONSULT-III Function (TRANSMISSION) .
Does A/T shift from D3 to D4 and does vehicle decelerate by engine brake?
YES - 1. Stop vehicle.
2. Go to SEE Cruise Test - Part 3 .
NO - - Mark the box on the "Diagnostic Worksheet Chart".
- Go to .
- Continue "Road Test".