Rear Wiper Arm

REAR WIPER AND WASHER SYSTEM


Removal and Installation


REAR WIPER ARM

Removal





1. Raise wiper arm cover (1), and remove the rear wiper arm nut
(A).
2. Remove the wiper arm.
3. Remove wiper blade.

Installation
1. Operate rear wiper motor one full cycle, then turn "OFF" (Auto Stop).





2. Clean pivot area as shown. This will reduce the possibility of wiper arm looseness.
3. Install wiper blade.
4. Install wiper arm so that the arm rests in the stopper and tighten rear wiper arm nut.
5. Install wiper arm cover.

REAR WIPER MOTOR











Removal
1. Remove wiper arm. Refer to "REAR WIPER ARM" .
2. Raise arm cap.
3. Remove the rear wiper motor nut, remove the rear wiper arm and blade.
4. Remove the back door lower finisher. .





5. Disconnect the rear wiper motor connector (B).
6. Remove the bolts (A) and remove the rear wiper motor (1).

Installation
Installation is in the reverse order of removal.

CAUTION:
Do not drop the wiper motor or cause it to contact other parts.

REAR WASHER TUBE LAYOUT











NOTE:





Connect the check valve (2) to the washer fluid tube (1) so that the directional arrow on the check valve (2) points towards the washer nozzle tube (3).

REAR WASHER NOZZLE

Removal
1. Remove the back door side garnish. .
2. Disconnect rear washer tube from rear washer nozzle.





3. Release retaining clips and remove washer nozzle.

Installation
Installation is in the reverse order of removal.

NOTE:
- Do not pinch the rear washer tube when installing the back door side garnish.
- Inspect rear washer nozzle for proper spray pattern, adjust as necessary. Rear Washer Nozzle Adjustment.

WASHER FLUID RESERVOIR
Service and Repair .

WIPER AND WASHER SWITCH
Service and Repair .

WASHER MOTOR
Service and Repair .