Special Repair Requirement

INSPECTION AND ADJUSTMENT

M/T NEUTRAL POSITION LEARNING : Special Repair Requirement


1. START

Do you have CONSULT?
Do you have CONSULT?
YES- GO TO 2.
NO- GO TO 3.

2. PERFORM M/T NEUTRAL POSITION LEARNING

With CONSULT
1.Check that there is no sticking when shifting shift lever to the neutral position.
2.Turn ignition switch ON.
3.Select "M/T NEUTRAL POS LEARN" in "WORK SUPPORT" mode with CONSULT.
4.Touch "Start" and wait a few seconds.
NOTE:
Never touch shift lever. Otherwise learning may not complete normally.
5.Make sure the "COMPLETE" is displayed on CONSULT screen.
NOTE:
If "INCMP" is displayed, return to step 1 and repeat the procedures again.
- END

3. PERFORM M/T NEUTRAL POSITION LEARNING

Without CONSULT
NOTE:
-It is better to count the time accurately with a clock.
-It is impossible to switch the learning mode when a clutch interlock switch circuit has a malfunction.
1.Check that there is no sticking when shifting shift lever to the neutral position.
2.Turn ignition switch ON and wait 5 seconds.
3.Within 5 seconds repeat the following operation 3 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
4.Wait 3 seconds while S-MODE switch is released.
5.Wait 5 seconds while pressing S-MODE switch.
6.Wait 3 seconds while S-MODE switch is released.
7.Within 5 seconds repeat the following operation 5 times. Fully depress and fully release clutch pedal while pressing and holding S-MODE switch.
ECM starts M/T Neutral Position Learning.
NOTE:
Never touch shift lever. Otherwise learning may not complete normally.





8.Shift position indicator on combination meter blinks for 5 seconds when the leaning is complete.
NOTE:
If shift position indicator does not blink or blinks continuously, return to step 1 and repeat the procedures again.
- END