Removal And Installation

BACK-UP LAMP SWITCH

Removal and Installation


REMOVAL

1.Disconnect the battery cable from the negative terminal.





2.Disconnect clip (A) from bracket (1).





3.Remove bracket from rear extension.
4.Disconnect back-up lamp switch connector.





5.Remove back-up lamp switch from rear extension.






INSTALLATION






1.Temporarily tighten back-up lamp switch onto rear extension by rotating once or twice.

CAUTION:
Remove old sealant and oil adhering to threads.
2.Apply recommended sealant to threads of back-up lamp switch as shown in the figure.
-Use Genuine Silicone RTV or an equivalent. Recommended Chemical Products And Sealants.





3.Tighten back-up lamp switch to the specified torque.





4.For the next step and after, install in the reverse order of removal.