Assembly

SHIFT FORK AND FORK ROD

Assembly

For assembly procedures other than the following items, refer to "SHIFT FORK AND FORK ROD" in Assembly Without S-Mode (Without S-MODE) or Assembly With S-Mode (With S-MODE).

CHECK SHIFT PIN






1.Set the control bracket to a vise and then install check shift pin (1) to control bracket.
2.Tighten check shift pin to the specified torque.

STRIKING ROD






1.Install low/high control lever to striking rod and then install retaining pin (black arrow) to low/high control lever, using a pin punch
[Commercial service tool].

CAUTION:
- Never reuse retaining pin.
- Be careful with the orientation of low/high control lever and striking rod.
- Assemble retaining pin from the direction shown by the arrow in the figure until it becomes flush with the end surface of low/high control lever.





2.Install stopper ring to striking rod and then install retaining pin (black arrow) to stopper ring, using a pin punch [Commercial service tool].






CAUTION:
- Never reuse retaining pin.
- Be careful with the orientation of stopper ring and striking rod.
- Assemble retaining pin from the direction shown by the arrow in the figure until it becomes flush with the end surface of stopper ring.