Disassembly

SHIFT FORK AND FORK ROD

Disassembly

For disassembly procedures other than the following items, refer to "SHIFT FORK AND FORK ROD" in Disassembly Without S-Mode (Without S-MODE) or Disassembly With S-Mode (With
S-MODE).

CHECK SHIFT PIN






Set the control bracket to a vise and then remove check shift pin (1)
from control bracket.

STRIKING ROD






1.Remove retaining pin (black arrow), using a pin punch [Commercial service tool] and then remove stopper ring from striking rod.










2.Remove retaining pin (black arrow), using a pin punch [Commercial service tool] and then remove low/high control lever from striking rod.