Roadster

INSPECTION AND ADJUSTMENT

ADDITIONAL SERVICE WHEN REPLACING CONTROL UNIT : Special Repair Requirement


INITIALIZATION PROCEDURE

1.Disconnect battery negative terminal or power window switch connector. Reconnect it after a minute or more.
2.Close door (door switch OFF).
3.Turn ignition switch ON.
4.Close roof.
5.Operate power window switch to fully open the window. (This operation is unnecessary if the window is already fully open.)
6.Pull up and hold power window switch. Even after glass stops at the fully closed position, keep pulling the switch for 3 seconds or more.
7.Inspect anti-pinch function.

CAUTION:
When initialization is not complete, power window UP does not operate while door is open.

CHECK ANTI-PINCH FUNCTION

1.Fully open the door window.
2.Place a piece of wood near fully closed position.
3.Close door glass completely with AUTO-UP.
- Check that glass lowers for approximately 150 mm (5.9in) without pinching piece of wood and stops.
- Check that glass does not rise when operating the power window main switch while lowering.

CAUTION:
- Do not check with hands and other part of body because they may be pinched. Do not get pinched.
- Check that AUTO-UP operates before inspection when system initialization is performed.
- Perform initial setting when auto-up operation or anti-pinch function does not operate normally.
- Finish initial setting. Otherwise, next operation cannot be performed.
1.Auto-up operation
2.Anti-pinch function
3.Automatic window adjusting function
4.Key cylinder switch power window function
5.Power window UP operation while door is open