Without Intelligent Key System

HOOD LOCK

Inspection

NOTE:
If the hood lock cable is bent or deformed, replace it.
1.Check that secondary latch is securely engaged with securely striker from the dead load of the hood assembly.
2.Check that primary latch is securely engaged with primary striker when hood assembly is closed [free-fall from approximately 200 mm (7.874 in) height].

CAUTION:
Never free-fall hood assembly from a height of 300 (11.811 in) mm or more.
3.While operating the hood opener carefully, check that the front end of the hood is lifted by approximately
20 mm (0.787 in) (A). Also, check that the hood opener returns to the original position.










4.Check that secondary latch is properly engaged with secondary striker [6.8 mm (0.268 in)] (B).





5.Check the hood lock lubrication condition. If necessary, apply body grease to hood lock.

Black arrow indicates : Grease up point