Seatback

REAR SEAT

SEATBACK : Disassembly and Assembly


DISASSEMBLY

LH side seatback
1.Remove headrest holder.





1.Pull seat lock cover in direction indicated by the arrow as shown in the figure. Remove seat lock cover.

Broken square indicates : Metal Clip





2.Pull tether cover in direction indicated by the arrow as shown in the figure. Remove tether cover.

Broken triangle indicates : Pawl





3.Open seatback fastener (A) and remove seatback retainer (B).





4.Use pincers, etc., to press up pawls as shown by the arrows in the figure, and remove headrest holder from seatback.

CAUTION:
Before installing headrest holder check its orientation.
(front/rear and right/left)
2.Remove seatback lock knob finisher.





1.Rotate seatback lock knob counterclockwise. Remove seatback lock knob.





2.Push up seatback lock knob finisher while pressing pawls indicated by arrows as shown in the figure. Remove seatback lock finisher from seatback.

CAUTION:
When installing seatback lock knob finisher, check front and rear orientation and be careful to install it normally.
3.Remove center seat belt finisher from seatback.





Lift up front of center seat belt finisher. Disengage front pawls.
Pull center seat belt finisher toward seat front. Disengage rear pawls.

Broken triangle indicates : Pawl

4.Remove seatback trim and seatback pad from seatback frame
5.Remove hog rings, and separate the seatback trim and seatback pad.

CAUTION:
Before performing separating operation, check the installation position of hog rings.
6.Remove seatback silencer from seatback frame.
7.Remove seatback lock assembly mounting bolts, and then remove seatback lock assembly from seatback frame.
8.Remove center seat belt retractor from seatback frame.
Rear Seat Belt.
RH side seatback
1.Remove headrest holder.





1.Pull seat lock cover in direction indicated by the arrow as shown in the figure. Remove seat lock cover.

Broken square indicates : Metal Clip





2.Pull tether cover in direction indicated by the arrow as shown in the figure. Remove tether cover.

Broken triangle indicates : Pawl






3.Open seatback fastener (A) and remove seatback retainer (B).





4.Use pincers, etc., to press up pawls as shown by the arrows in the figure, and remove headrest holder from seatback.

CAUTION:
Before installing headrest holder check its orientation.
(front/rear and right/left)
2.Remove seatback lock knob finisher.





1.Rotate seatback lock knob counterclockwise. Remove seatback lock knob.





2.Push up seatback lock knob finisher while pressing pawls indicated by arrows as shown in the figure. Remove seatback lock finisher from seatback.

CAUTION:
When installing seatback lock knob finisher, check front and rear orientation and be careful to install it normally.
3.Remove seatback trim and seatback pad from seatback frame.
4.Remove hog rings, and separate the seatback trim and seatback pad.

CAUTION:
Before performing separating operation, check the installation position of hog rings.
5.Remove seatback silencer from seatback frame.
6.Remove seatback lock assembly mounting bolts, and then remove seatback lock assembly from seatback frame.

INSTALLATION

Note the following, and assemble in the reverse order of disassembly.

CAUTION:
Always install the hog ring in position.