Removal And Installation

OIL PUMP

Removal and Installation


REMOVAL

1.Remove engine assembly. Exploded View (2WD) , "4WD (AWD) :
Exploded View" (AWD).
2.Remove oil pan (lower). Removal And Installation.
3.Remove front cover, and other related parts. Exploded View.
4.Remove oil pump sprocket with the following procedure:
- Add matching mark if necessary for easier installation.





a.Push oil pump drive chain tensioner (1) in the direction show in the figure.
b.Insert a stopper pin (A) into the body hole (B).
c.Remove oil pump chain tensioner.
- When the holes on lever and tensioner body cannot be aligned, align these holes by slightly moving the oil pump chain tensioner slack guide.





d.Hold the WAF part of oil pump shaft [WAF: 10 mm (0.39 in)] (A), and then loosen the oil pump sprocket bolt and remove it.

1 : Oil pan (upper)
White arrow indicates : Engine front

CAUTION:
- Secure the oil pump shaft with the WAF part.
- Never loosen the oil pump sprocket bolt by tightening the oil pump drive chain.
e.Remove oil pump sprocket.
5.Remove oil pump.





- Loosen bolts in reverse order as shown in the figure.






INSTALLATION

Note the following, and install in the reverse order of removal.
Oil Pump





- Tighten bolts in numerical order as shown in the figure.