Front Drive Shaft Left Side
FRONT DRIVE SHAFT
LEFT SIDE : Removal and Installation
REMOVAL
1.Remove tires with power tool. Removal And Installation.
2.Remove wheel sensor and sensor harness. Exploded View.
3.Remove lock plate from strut assembly. Removal and Installation.
4.Remove caliper assembly. Hang caliper assembly not to interfere with work. Removal And Installation.
CAUTION:
Never depress brake pedal while brake caliper is removed.
5.Remove disc rotor. Removal And Installation.
6.Remove cotter pin, and adjusting cap, and then loosen wheel hub lock nut with power tool. Removal And Installation.
7.Patch wheel hub lock nut with a piece of wood. Hammer the wood to disengage wheel hub assembly from drive shaft.
NOTE:
Use suitable puller, if wheel hub assembly and drive shaft cannot be separated even after performing the above procedure.
8.Remove wheel hub lock nut. Removal And Installation.
9.Remove strut assembly from steering knuckle. Removal and Installation.
10.Remove shaft assembly from wheel hub assembly.
CAUTION:
- Never place drive shaft joint at an extreme angle. Also be careful not to overextend slide joint.
- Never allow drive shaft to hang down without support for joint sub-assembly, shaft and the other parts.
11.Use the drive shaft attachment (A) [SST:KV-40107500 (-)]
and a sliding hammer (B) (commercial service tool) while inserting tip of the drive shaft attachment between shaft and transaxle assembly, and then remove drive shaft from transaxle assembly.
CAUTION:
- Never place drive shaft joint at an extreme angle when removing drive shaft. Also be careful not to overextend slide joint.
- Confirm that the circular clip is attached to the drive shaft.
12.Perform inspection after installation. Front Drive Shaft.
INSTALLATION
Note the following, and install in the reverse order of removal.
Transaxle Side
- Always replace differential side oil seal with new one when installing drive shaft. Removal And Installation (M/T) or [CVT (2WD)], Removal And Installation [CVT (AWD)].
- Place the protector (A) [SST:KV-38107900 (-)] onto transaxle assembly to prevent damage to the oil seal while inserting drive shaft. Slide drive shaft sliding joint and tap with a hammer to install securely.
CAUTION:
Check that circular clip is completely engaged.
- Perform inspection after installation. Front Drive Shaft.
Wheel Hub Side
- Clean the matching surface of wheel hub lock nut and wheel hub assembly.
CAUTION:
Never apply lubricating oil to these matching surface.
- Clean the matching surface of drive shaft and wheel hub assembly.
And then apply paste [service parts (440037S000)] to surface (A)
of joint sub-assembly of drive shaft.
CAUTION:
Apply paste to cover entire flat surface of joint sub-assembly of drive shaft.
Amount paste: 1.0 - 3.0 g (0.04 - 0.10 oz)
- Use the following torque range for tightening the wheel hub lock nut.
CAUTION:
- Since the drive shaft is assembled by press-fitting, use the tightening torque range for the wheel hub lock nut.
- Be sure to use torque wrench to tighten the wheel hub lock nut. Never use a power tool.
- Never reuse wheel hub lock nut.
NOTE:
Wheel hub lock nut tightening torque does not over torque for avoiding axle noise, and does not less than torque for avoiding looseness.
- Align the matching marks that have been made during removal when reusing the disc rotor.
- When installing a cotter pin (1) and adjusting cap (2), securely bend the basal portion to prevent rattles.
CAUTION:
Never reuse cotter pin.
- Perform the final tightening of each of parts under unladen conditions, which were removed when removing wheel hub assembly and steering knuckle.
- Perform inspection after installation. Front Drive Shaft.