With Intelligent Key System

FRONT DOOR

DOOR ASSEMBLY : Adjustment












Check the clearance and surface height between front door and each part by visually and touching.
If the clearance and the surface height are out of specification, adjust them according to the procedures shown below.






FITTING ADJUSTMENT PROCEDURE

1.Remove front fender. Refer to With Intelligent Key System.
2.Loosen door hinge mounting nuts on door side.
3.Adjust the surface height of front door according to the fitting standard dimension.
4.Temporarily tighten door hinge mounting nuts on door side.
5.Loosen door hinge mounting bolts on body side.
6.Raise front door at rear end to adjust clearance of the front door according to the fitting standard dimension.
7.After adjustment tighten bolts and nuts to the specified torque.

CAUTION:
- After installation, apply touch-up paint (the body color) onto the head of hinge mounting bolts and nuts.
- Check door hinge rotating part for poor lubrication. If necessary, apply body grease.
8.Install front fender. Refer to With Intelligent Key System.

DOOR STRIKER ADJUSTMENT

Adjust door striker so that it becomes parallel with door lock insertion direction.