Front Door: Service and Repair

DOOR


Removal and Installation


FRONT DOOR

CAUTION:
- When removing and installing the front door assembly, support the door with a jack and cloth to protect the door and body.
- When removing and installing front door assembly, be sure to carry out the fitting adjustment. Adjustments.
- After installing, apply touch-up paint onto the head of the hinge nuts.
- Check the hinge rotating part for lubrication. If necessary, apply "body grease".
- Operate with two workers, because of its heavy weight.
- Check front door open/close operation after installation.

Removal
1. Remove dash side finisher. .
2. Disconnect the front door harness connectors.





3. Remove the front door harness grommet, and then remove the harness from the vehicle.





4. Remove the check link bolt.






5. Remove the hinge nuts and then the door assembly.


Installation
Installation is in the reverse order of removal.

REAR DOOR

CAUTION:
- When removing and installing the rear door assembly, support the door with a jack and cloth to protect the door and body.
- When removing and installing rear door assembly, be sure to carry out the fitting adjustment. Adjustments.
- After installing, apply touch-up paint onto the head of the hinge nuts.
- Check the hinge rotating part for poor lubrication. If necessary, apply "body grease".
- Operate with two workers, because of its heavy weight.
- Check rear door open/close operation after installation.

Removal





1. Remove the rear door harness grommet.





2. Disconnect the rear door harness connector.





3. Remove the check link bolt.






4. Remove the hinge nuts and the door assembly.


Installation
Installation is in the reverse order of removal.

BACK DOOR

Removal
1. Remove the back door glass. .
2. Remove the back door lock assembly.
3. R01797>emove the back door wire harness.
4. Remove the rear washer nozzle and hose from the back door. .
5. Support the back door.

CAUTION:
Two technicians should be used to avoid damaging the back door during removal.
6. Remove the back door stays.
7. Remove the door side nuts and the back door assembly.






Installation
Installation is in the reverse order of removal.
- Align the back door. Adjustments.