Removal and Installation

FRONT SEAT

Removal and Installation


CAUTION:
- When removing and installing, use shop cloths to protect parts from damage.
- Before removal, be sure to turn ignition switch OFF, disconnect both battery terminals, then wait for at least three minutes.

REMOVAL

1.Disconnect the negative and positive battery terminals, then wait at least three minutes.
2.Remove the seat assembly bolts on the back side of the front seat.
3.Remove the seat assembly bolts on the front side of the front seat.
4.Disconnect the body harness connector(s), then release the harness clips from the seat assembly.
5.Remove the front seat assembly from the vehicle.
NOTE:
Before removing the seat assembly from the vehicle, adjust the seatback to the upright position.

INSTALLATION

Installation is in the reverse order of removal.

CAUTION:
Always route the side air bag module harness in the original location. Replace any deformed or damaged clips with the same type and color. Always install clips in the original location on the harness.
NOTE:
- Before installation of the seat assembly, confirm that the inside and outside slide rails are both locked at the same positions.
- Confirm that the slide rail locating pin is set to the locating hole on the floor.