ID Registration Procedure

TROUBLE DIAGNOSES

ID Registration Procedure

NOTE:
The Signal Tech II Tool (J-50190) can be used to perform the following functions. Refer to the Signal Tech II
User Guide for additional information.
- Activate and display TPMS transmitter IDs
- Display tire pressure reported by the TPMS transmitter
- Read TPMS DTCs
- Register TPMS transmitter IDs

ID REGISTRATION WITH TRANSMITTER ACTIVATION TOOL

NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295.
1.Connect CONSULT.
2.Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
3.Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".





4.Push the transmitter activation tool against the tire near the front left transmitter. Press the button for 5 seconds.
Tool number: (J-45295)
5.Register the IDs in order from FR LH, FR RH, RR RH and RR LH. When ID registration of each wheel has been completed, a buzzer sounds and the hazard warning lamps flash.





6.After completing all ID registrations, press "END" to complete the procedure.
NOTE:
Be sure to register the IDs in order from FR LH, FR RH, RR RH, to RR LH, or the self-diagnostic results display will not function properly.

ID REGISTRATION WITHOUT TRANSMITTER ACTIVATION TOOL

NOTE:
This procedure must be done after replacement of a TPMS transmitter or BCM. New replacement transmitters are provided "asleep" and must first be "woken up" using Transmitter Activation Tool J45295 or Signal Tech II Tool J-50190 before ID registration can be performed. Use the following procedure when using the Transmitter Activation Tool J-45295.
1.Connect CONSULT.
2.Select "AIR PRESSURE MONITOR" on "SELECT TEST ITEM" screen.
3.Select "WORK SUPPORT" on "SELECT DIAG MODE" screen, and select "ID REGIST".
4.Adjust the tire pressure to the values shown in the table below and drive the vehicle at 15 km/h (9.4 MPH)
or more for a few minutes.





5.After completing all ID registrations, press "END" to complete the procedure.





6.Inflate all tires to proper pressure. Specifications .