Control Linkage

CONTROL LINKAGE

Removal and Installation


REMOVAL

1.Remove battery. Removal and Replacement.
2.Remove air duct (front), air duct (Inlet) and air cleaner case. Removal And Installation.
3.Remove shift selector cable from control shaft shift lever.
4.Remove select cable according to the following.





a.Move stopper (1) to the unlocked position.





b.Pull the release button (1) of select cable (2) and then remove it from control shaft select lever (3).
5.Move shift selector to neutral position.
6.Remove shift selector handle.
7.Remove center console assembly. Removal And Installation.
8.Remove M/T shift selector assembly bolts.
9.Remove exhaust front tube, center muffler and heat plate. Removal And Installation.
10.Remove cable support bracket.
11.Remove select cable and shift selector cable from cable bracket.
12.Remove M/T shift selector assembly from the vehicle.

INSTALLATION

Installation is in the reverse order of removal.
NOTE:
Self-tapping bolts are used to attach cables to the clutch housing.
- Securely assemble each cable and lever of control shaft.





- Be careful about the installation direction, and push shift selector handle onto shift selector.

CAUTION:
Do not reuse shift selector handle.





- Make sure that the front/rear pawls (1) of M/T shift selector assembly are in contact with flange of the floor (2).
- When shift selector is moved to 1st-2nd side and 5th-6th side, confirm shift selector returns to neutral position smoothly.
- When shift selector is moved to each position, make sure there is no binding or disconnection in each boot.





- Move stopper (1) to lock position when installing the shift cable onto the control shaft shift lever.